Ready-remote 24927 Manuel d'utilisateur télécharger pdf (Page 30)

of insulation off the tachometer wire in the vehicle and solder the

green tachometer input wire to it. Then wrap the connection with

electrical tape.

LEARNING YOUR TACH SIGNAL

If using a tach wire, you must learn the tach signal after

completing the installation.

To learn tach signal:

1. Start car with key

2. Wait about 5 seconds for the engine to idle down

3. Press and hold the Momentary switch (about 10

seconds)

4. Tach learned: After a few seconds the LED will flash 2

times and turn on. Continue to hold the switch for 2 - 3

seconds and release.

5. Tach not learned: The LED will not turn on and will flash

3 times when the momentary switch is released. Check

the connections and try again.

note! If using a tach signal, the tach signal MUST

be learned before using the remote starter.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 78 79

Pas de commentaire

Ready-remote 24927 Manuel d'utilisateur Page 30