Ready Remote 24927 Guide d'installation télécharger pdf (Page 21)

Many Nissan and Toyota vehicles have two starter wires. A relay

and/or resistor (not provided) is required to hook up the addi-

tional starter wire. Refer to the diagram below.

Once you locate the starter wire, cut the wire in half (check the

web information before cutting) and try to start the vehicle. If

the vehicle does not start, the correct wire has been identified.

Reconnect both ends of the starter wire while soldering the thick

YELLOW (6) wire of the heavy guage wires to it and wrap the

connection with electrical tape.

Note! Always check the Web site information

on your vehicle for warnings regarding the

starter wire and check engine lights. Some

vehicles will trip a check engine light if the

starter wire is cut.

87A

+12 VDC CONSTANT (FUSED 20A)

GROUND

TO 2

STARTER

YELLOW (+) OUTPUT

TO STARTER

STARTER RELAY

(NOT PROVIDED)

87A

+12 VDC CONSTANT (FUSED 20A)

GROUND

TO STARTER

STARTER RELAY

(NOT PROVIDED)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 94 95

Pas de commentaire

Ready Remote 24927 Guide d'installation Page 21